Unit 10 Report

jewels.p

When you are doing the Unit 10 Report where in the report do you put all the information required for 10.1. Job Description, Training, Contingency Planning etc. On here and in my guidance book It gives the Report Contents as

Title Page
Contents Page
Terms of Reference
Management Summary
Methodology
Intro
Analysis and evaluation of current system
Recommendations
Cost benefit analysis
Appendices
Managers authenticity
Mapping

Terdoo

Re Report

I think your title should be on the the front cover of your project followed by your membership number and your name
10.1 A should be planing of resources
10.1B review competence
10.1C Contingency
10.1D Communication
10.1E Monitor quality
10.1F Co ordinate method contingency
10.1G Encourage collegues to report problems
10.1H Referal of problem to others

Then 10.2A SWOT Analysis and so forth

10.2B Address fraud

hope this helps

A-Vic

1. Title Page
2. Table of Contents
3. Acknowledgments
Management Summary
4. Terms of Reference
5. Introduction
6. Analysis of Current Situation
7. Preliminary Findings
8. SWOT Analysis
9. Objectives of Findings
10. Research and Recommendations
11. Cost benefit and Fraud analysis
12. Appendix

And the very frount went my mapping document

jewels.p

A-Vic wrote: »

1. Title Page
2. Table of Contents
3. Acknowledgments
Management Summary
4. Terms of Reference
5. Introduction
6. Analysis of Current Situation
7. Preliminary Findings
8. SWOT Analysis
9. Objectives of Findings
10. Research and Recommendations
11. Cost benefit and Fraud analysis
12. Appendix

So in which number of the above did you put your contingency planning etc?

Rinske

I had it touched in my SWOT analysis and then further suggestions made in the recommendations.